Do NOT redeem

Lol freaking autocorrect 🙃

In general, I guess I don’t know, but ours is fine. The drying is weak shit in comparison and I miss our giant American dryer

I think I see what’s going on here.

If you have a combo washer/dryer (common at least where I am in Europe), the lint trap is wet and it uses water to rinse it towards a collection point. I use a paper towel to pull it out each load.

Stærk Stark contrast to separate washer/dryer which will have a dry lint trap in the dryer.

Ed is (to me, and to the poster of this meme) a rational voice in a storm of media knee-bending to corporations and billionaires who are openly hostile to people, the environment, the economy, everything.

He reacts passionately calling them out on their scam. Nice that he’s getting more and more legit attention and media appearances

Det ved jeg godt :)

But it’s fun to show that meme off. Danish numbers are wild. My bad danish gets me mistaken numbers all the time

And the Danes will think you’re talking about 50

deleted by creator

Anyone know where I can read more about this old Chinatown in CDMX? I can’t seem to find non meme posts about it

Update: sorry to be an OP who didn’t deliver. My buddy never made the measurement. I’m hoping he will. Sorry everyone!

This is all I found on their site about it, which aligns but isn’t as much detail as I hoped

With standard and heavy duty foil, it’s perfectly fine to place your food on either side so you can decide if you prefer to have the shiny or dull side facing out.

Okay, my buddy is gonna take foil tomorrow and run it over the profilometer (?) tomorrow and see. I’ll report back with more numbers and less hand waving when I have it

Former process engineer in an aluminum factory. Aluminum foil is only shiny on one side and duller on the other for process reasons, not for any “turn this part towards baking, etc” reasons.

It’s just easier to double it on itself and machine it to double thickness than it is to hit single thickness precision, especially given how much more tensile strength it gives it.

Also, our QA lab did all kinds of tests on it to settle arguments. The amount of heat reflected/absorbed between the two sides is trivially small. But if you like one side better you should wrap it that way, for sure!