Yeah, inside the case, under a layer. I printed the PLA layers, paused the print to insert the magnets and change to TPU filament, then resumed.
I had to extend a bump outside of the case a bit to accommodate the depth, but the bump worked nicely as a coping to seat the phone tightly in the mount so it didn’t come loose with e.g. road bumps in the car.
*cries in Bowden tube*
You can do it. I designed and printed my phone case in TPU on an Ender 3.
It even used two materials. PLA for the hard outer face, and TPU from there up giving a soft interface and bumper edge.
TPU does generally suck on a Bowden machine. Stringing galore!
I just now realized I could do this easily with my U1. It might be time for me to make a phone case 2.0
I printed mine with (4) 15×2mm magnets embedded which allowed me to easily attach it to a variety of desk and auto mounts.
I did this about 2 weeks before the iPhone started doing that, so I felt special for about that long. But it was extremely handy.
Embedded?! Like inside, under a layer? Or tucked in a divot?
Yeah, inside the case, under a layer. I printed the PLA layers, paused the print to insert the magnets and change to TPU filament, then resumed.
I had to extend a bump outside of the case a bit to accommodate the depth, but the bump worked nicely as a coping to seat the phone tightly in the mount so it didn’t come loose with e.g. road bumps in the car.
Damn. That’s awesome. I gotta start getting more creative with my ender3.